Oxy-Acetylene Torch Settings Chart

Oxy-Acetylene Torch Settings Chart – Check the thickness of the metal to be cut or welded. Matt foster from uniweld mentioned several operating tips for torch tips and setting a flame. Refer to welding tip selection chart to determine the recommended tip size and regulator pressure setting for the job. This is the first edition of the.

· open fuel gas valve 1/2 turn. While an instruction manual is the definitive guide for preparing to. 100 litre per mm thickness. Initial start up, changing tips and pressures, setting the flame, shutting down the torch set.

Oxy-Acetylene Torch Settings Chart

· separately purge both oxygen and fuel gas lines. The most common torch tip he finds most technicians use is the type. Selecting your welding attachment depending on plate/ wall thickness.

First, we must clean the nozzle because if the head of the nozzle is dirty will cause a flame bad. · increase fuel gas flow until flame leaves. Consult the torch manufacturer for proper pressure settings for acetylene and oxygen.

The table below includes our recommendations of kits when it comes. Smith torch tip charts can be found in the manuals supplied with every torch or at millerwelds.com. · ignite flame with striker.

If you don’t have a manual you can download the attc equipment manual here. Lighting and adjusting the torch (with a positive/equal pressure mixer): Best oxy acetylene torch kit sets.

Cutting Torch Guide